LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Clutch & Seal Removal & Installation >> NIPPONDENSO 10PA20 10-CYL Clutch >> Removal

NIPPONDENSO 10PA20 10-CYL Clutch: Removal

  1. Using Clutch Plate Spanner (J-33027) and a thin-wall socket, remove crankshaft bolt. Using Clutch Plate Remover (J-37252), remove clutch plate. Remove clutch plate shims.
  2. Remove pulley assembly snap ring. Using a plastic hammer, tap pulley assembly from compressor. Remove snap ring and remove clutch coil. Inspect all parts for damage.
scientia non olet · About LEMON Manuals