LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Clutch & Seal Removal & Installation >> NIPPONDENSO 10PA17 & 10PA17A 10-CYL Shaft Seal >> Removal

NIPPONDENSO 10PA17 & 10PA17A 10-CYL Shaft Seal: Removal

  1. Remove compressor and drain refrigerant oil. Install compressor in Holding Fixture (T89P-19623-D) and clamp fixture in a vise. Remove clutch plate, pulley assembly and clutch coil. Using a 6 mm Allen wrench, remove 5 compressor through bolts. Pull front head from compressor using care not to scratch sealing surface. See Figure .
  2. Using "O" Ring Remover (T71P-19703-C), remove felt dust seal and retainer from front head. Remove shaft seal retaining snap ring. Position front head (nose up) on cardboard place on a flat surface. Using Shaft Seal Remover (T89P-19623-E), push shaft seal from head. Inspect front head for damage to sealing surface. Replace if necessary.
scientia non olet · About LEMON Manuals