LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Clutch & Seal Removal & Installation >> NIPPONDENSO 10PA17 & 10PA17A 10-CYL Shaft Seal >> Installation

NIPPONDENSO 10PA17 & 10PA17A 10-CYL Shaft Seal: Installation

  1. Lubricate new shaft seal with refrigerant oil. DO NOT touch sealing surfaces. Using Shaft Seal Installer (T89P-19623-F), press seal into front head and install snap ring. Install felt dust seal and retainer.
  2. Lubricate Shaft Seal Protector (T89D-19623-C) with refrigerant oil and install on crankshaft. Install a new front head "O" ring on cylinder assembly and coat with refrigerant oil.
  3. Install front head on cylinder assembly. Ensure dowel pins are aligned. Use care when guiding shaft seal protector through seal opening. Remove shaft seal protector. Install through bolts with NEW brass washers. Diagonally tighten bolts to 19 ft. lbs. (26 N.m). Add amount of refrigerant oil that was drained to the compressor. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals