LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Clutch & Seal Removal & Installation >> NIPPONDENSO 10PA17 & 10PA17A 10-CYL Clutch >> Installation

NIPPONDENSO 10PA17 & 10PA17A 10-CYL Clutch: Installation

  1. Install clutch coil over locating tab. Install snap ring. Install pulley assembly and install snap ring. Apply a thin coat of White grease to compressor shaft splines.
  2. Install clutch plate spacer shims. Slide compressor clutch on crankshaft and install NEW retaining bolt. Tighten bolt to 96-120 INCH lbs. (11-14 N.m). Using a feeler gauge, rotate clutch assembly and check clearance between pulley and clutch plate in 3 places. Proper clearance is .014-.026" (.36-.66 mm). If clearance is not correct, add or remove shims.
Fig 1: Exploded View Of Nippondenso 10PA17 & 10PA17A 10-Cyl Compressor
G104028Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals