LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Clutch & Seal Removal & Installation >> NIPPONDENSO 10P15 & 10P15F, Shaft Seal >> Installation

NIPPONDENSO 10P15 & 10P15F, Shaft Seal: Installation

  1. Place Shaft Seal Protector (T71P-19703-H) on compressor crankshaft. Lubricate shaft seal and nose of compressor with new refrigerant oil. DO NOT touch sealing surface of seal or shaft. Engage seal tangs on shaft seal remover/installer.
  2. Align flats of seal with flats on crankshaft and push new seal on crankshaft. Push down on shaft seal remover/installer and turn counterclockwise to disengage seal tangs.
  3. Attach shaft seal seat to shaft seal seat remover/installer and lubricate with new refrigerant oil. Install seal and push inward against the seal. Install seal seat snap ring. Install felt and felt retainer. Install clutch plate key with rounded end toward compressor. Fill compressor with amount of oil drained from compressor. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals