LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Clutch & Seal Removal & Installation >> NIPPONDENSO & Ford FS-6, 6-CYL Clutch >> Removal

NIPPONDENSO & Ford FS-6, 6-CYL Clutch: Removal

  1. Use Spanner (T81P-19623-MH) to hold clutch plate and remove crankshaft nut. Using Clutch Plate Remover (T80L-19703-B), pull clutch plate from compressor. Remove clutch plate shims.
  2. Remove snap ring and clutch pulley assembly. If pulley assembly cannot be removed by hand, use Shaft Protector (T80L-19703-G) and 3-jaw puller to remove pulley. Remove snap ring. Disconnect electrical wiring and remove clutch coil.
scientia non olet · About LEMON Manuals