LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Clutch & Seal Removal & Installation >> Ford FX-15 10-CYL Shaft Seal >> Removal

Ford FX-15 10-CYL Shaft Seal: Removal

  1. Discharge system using approved refrigerant recovery/recycling equipment and remove compressor. Remove clutch plate. Using "O" Ring Remover (T71P-19703-C), remove shaft felt seal. Thoroughly clean seal area of compressor. Using snap ring pliers, remove shaft seal snap ring.
  2. Position Shaft Seal Remover (T89P-19623-BH) over compressor shaft and push shaft seal remover downward against seal. Ensure end of shaft seal remover is engaged with inside of seal. Rotate shaft seal remover handle clockwise to expand remover tip inside seal. Pull shaft seal from compressor.
scientia non olet · About LEMON Manuals