LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Clutch & Seal Removal & Installation >> Ford FX-15 10-CYL Shaft Seal >> Installation

Ford FX-15 10-CYL Shaft Seal: Installation

  1. Shaft seal protector is included with replacement seal kit. Lubricate shaft seal protector and shaft seal with refrigerant oil. Install shaft seal on shaft seal protector so lip of seal is toward the compressor (large end of shaft seal protector). Install shaft seal protector on compressor shaft.
  2. Using Shaft Seal Installer (T89P-19623-AH), push shaft seal down the shaft seal protector until seated. Remove shaft seal installer and protector. Install NEW shaft seal snap ring. Ensure snap ring is seated in ring groove. Install NEW shaft seal felt. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals