LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Clutch & Seal Removal & Installation >> Ford FX-15 10-CYL Clutch >> Removal

Ford FX-15 10-CYL Clutch: Removal

  1. Using Spanner (T70P-4067-A), remove clutch plate retaining bolt and discard. Using an 8-mm bolt threaded into clutch plate, remove clutch plate and shims. See Figure .
  2. Remove snap ring and remove pulley assembly. Disconnect electrical wiring to clutch coil. Install Shaft Protector (T89P-19623-FH) on nose opening of compressor. Install 2-jaw puller on compressor. Ensure puller screw is engaged in the center of shaft protector. Tighten puller to remove clutch coil from compressor.
scientia non olet · About LEMON Manuals