LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 2.9L V6 - VIN [T] >> Removal & Installation >> Camshaft Bearings >> Installation

Camshaft Bearings: Installation

  1. Install camshaft bearings using camshaft bearing installer. Ensure oil hole in bearing is aligned with oil hole in cylinder block. Front bearing must be installed .040-.060" (1.02-1.52 mm) from front face of block.
  2. Check oil hole alignment of number 2 and 3 bearings by inserting a rod of smaller diameter into oil passage. Rod should pass into camshaft bore. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals