LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Locking Hubs >> Transfer Cases Borg-WARNER 1350 & 1356 >> Front Output Shaft Oil Seal (Service (In-Vehicle)) >> Removal (Bronco & "F" Series)

Removal (Bronco & "F" Series)

Raise vehicle. Remove front drive shaft from transfer case yoke. Remove front drive shaft from transfer case yoke. Wire drive shaft out of way. Remove yoke. Using Seal Remover (T74P-77248-A) and Slide Hammer (T50T-100-A), remove oil seal. Remove oil slinger from yoke.

scientia non olet · About LEMON Manuals