LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Driveshaft & Universal Joints >> Drive Shaft >> Overhaul >> Double CARDAN Universal Joints >> Installation (1-Piece Shaft - Front)

Installation (1-Piece Shaft - Front)

  1. Clean yoke and inspect machined surface for scratches, nicks or burrs. Check for arrows on slip joint and drive shaft to aid in alignment.
  2. Connect single end of drive shaft to front axle. Install "U" bolts and tighten nuts. Connect double cardan joint to transfer case. Install "U" bolts and tighten nuts.
scientia non olet · About LEMON Manuals