LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Driveshaft & Universal Joints >> Drive Shaft >> Adjustments >> Drive Shaft Phasing >> 2-Piece Shafts

2-Piece Shafts

Rotate transmission until yoke ears are on a horizontal plane. If 2-piece shaft is correctly installed, center line of yoke ears at each end of individual shafts will be parallel. See Fig 1 . If flanges are not in same plane, remove drive shaft. Install drive shaft with yokes aligned to a horizontal plane. See Figure .

Fig 1: Phase Alignment Of 2-Piece Drive Shafts
G121059
scientia non olet · About LEMON Manuals