LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Adjustments >> Parking Brake (Except AEROSTAR) >> Final Adjustment

Final Adjustment

  1. Adjust service brakes before adjusting parking brake cable. Ensure brake drums are cold.
  2. Position parking brake pedal to fully depressed position. Grip tension limiter housing to prevent it from spinning. Tighten equalizer nut 6 full turns past its original position.
  3. Check cable tension at rear of equalizer assembly using Cable Tension Gauge (021-00018). Bronco II and Ranger tension should be 400-600 lbs. (182-272 kg). Tension for all other models should be 350 lbs. (159 kg). If tension is not to specification, repeat step 2).
  4. Release pedal and check rear wheel drag. If drag is noted, remove drums and check for clearance between parking brake lever and cam plate.
  5. Clearance should be .015" (.38 mm) with brakes fully released. If clearance is not to specification, readjust parking brake cable.
scientia non olet · About LEMON Manuals