LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Adjustments >> Brake Shoes >> Drums Installed

Drums Installed

  1. Raise vehicle and support with safety stands. Remove adjusting hole cover. Turn adjusting screw and expand brake shoes until drag is felt against brake drum.
  2. Loosen adjusting screw an additional 10 to 12 notches. Drum should rotate freely without drag. If drum does not rotate freely, remove wheel and drum lubricate touch marks on backing plate where brake shoes touch.
  3. Reinstall wheel and drum. Install adjusting hole cover. Apply brakes. If brake pedal travels halfway to floor, clearance between brake shoes and drums is to great.
scientia non olet · About LEMON Manuals