Turn Signal & Hazard Flasher Switches (Bronco, "F" Series): Installation
- Guide the turn signal switch wire harness through the openings provided in the shift socket and the left hand side of the brake and clutch pedal support bracket.
- On models equipped with automatic transmission, insert PRNDL lamp wire into the turn signal switch harness sheath. Install turn signal switch assembly retaining screws. Assemble wires into connector plug on models equipped with tilt column.
- Plug switch harness into main wiring harness. Ensure vinyl sleeve on switch harness covers all harness wires where they pass through opening in the left hand side of the brake and clutch pedal support bracket. If necessary, slide vinyl sleeve down the switch harness toward the harness connector so that the sleeve protrudes through opening.
- Install turn signal lever and tighten to 10-20 inch lbs. (1.2-2.25 N.m). Install steering wheel and retaining nut. Tighten wheel nut to 30-40 ft.lbs. (41-54 N.m). Install horn switch. Install steering column shroud and instrument panel steering column steering column opening cover. Connect battery ground cable.