Installation Without Key (Bronco, "E" & "F" Series With Non-Tilt Steering)
NOTE:
Retain ignition switch actuating rod from removed casting assembly for use with NEW flange casting assembly.
- Replace removed assembly with NEW assembly consisting of the following:
- Flange casting assembly.
- Lock cylinder assembly.
- Lock gear (steering column lock).
- Bearing (steering column lock).
- Retainer (steering column upper bearing).
- Actuator assembly (steering column lock).
- Lubricate ignition lock cylinder with grease. Install key release lever assembly on M/T equipped vehicles or "PRND2 1" insert on A/T equipped vehicles. Install "T" bolts and lock actuator insert. Reassemble NEW assembly parts. Install NEW upper shaft bearing and set actuator to drive gear. To complete installation, reverse removal procedure. Using ignition key, rotate ignition lock cylinder to ensure correct mechanical operation in all positions.