Bronco II & Ranger
- Disconnect negative battery cable. Remove 2 screws attaching steering column shroud to panel. Remove shroud. Remove lower instrument panel trim. Detach cluster trim cover attaching screws and remove cover. Remove 4 screws attaching cluster to panel. Pull cluster slightly away from panel. See Fig 1.
Courtesy of FORD MOTOR CO.
- Vehicles with automatic transmission require PRNDL indicator to be removed. Remove 2 screws attaching PRNDL to cluster. Slide PRNDL down and out of cluster. Disconnect speedometer cable at speedometer. If there is not enough room, detach cable at transmission. Disconnect wiring harness connector from printed circuit.
- Disconnect bulbs from sockets and remove instrument cluster. Before installation, apply a 3/16" ball of silicone lubricant to drive hole of speedometer head. To complete installation, reverse removal procedure. Check operation of all gauges, lights and signals.