Torque Specifications

TORQUE SPECIFICATIONS

Application

Ft. Lbs. (N.m)

Camshaft Sprocket Bolt

41-56 (55-75)

Connecting Rod Cap Nut

21-26 (28-35)

Crankshaft Damper Bolt

140-170 (190-230)

Cylinder Head Bolt

Step 1

51-59 (69-80)

Step 2

70-76 (95-103)

Distributor Hold-Down Bolt

17-25 (23-34)

Exhaust Manifold Bolt

Step 1

5-7 (7-10)

Step 2

20-30 (27-41)

Flywheel Mount Bolt

54-64 (73-87)

Intake Manifold Bolt

⁽¹⁾ 15-23 (20-31)

Intake Manifold Support Bracket Bolt

30-40 (41-54)

Main Bearing Cap Bolt

52-66 (71-90)

Oil Pan Bolts ⁽²⁾

Engine Block Bolts

15-22 (20-30)

Transaxle Bolts

30-39 (41-53)

Oil Pump Mount Bolt

30-39 (41-53)

Rocker Arm Bolt

Step 1

5-8 (7-11)

Step 2

20-27 (27-38)

Water Pump Mount Bolt

15-23 (20-30)

INCH Lbs. (N.m)

Camshaft Tensioner Bolt

72-108 (8-12)

Camshaft Thrust Plate Bolt

72-108 (8-12)

Crankshaft Seal Retainer Bolt

72-108 (8-12)

Timing Cover Bolts

72-108 (8-12)

⁽¹⁾	Tighten intake manifold to specification in 2 steps. Tightening torque applies to intake manifold-to-cylinder head and upper-to-lower intake manifold bolts.

⁽²⁾	If oil pan is installed with engine out of vehicle, a transaxle case or other fixture must be bolted to engine to align pan with rear face of block.