LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1989 >> Probe LX, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.2L 4-CYL - VIN [C] & 2.2L 4-CYL Turbo - VIN [L] >> Removal & Installation >> Cylinder Head >> Installation

Cylinder Head: Installation

  1. To install, reverse removal procedure. Ensure cylinder head bolt threads and cylinder block are clean. Ensure proper type cylinder head gasket is used. Different type gasket is used for non-turbo and turbo models.
  2. Apply light coat of oil to head bolts threads and seating surface prior to installation. Tighten cylinder head bolts to specification in 2 steps using proper sequence. See Fig 1. To install remaining components, reverse removal procedure. Ensure all timing marks are aligned.
Fig 1: Cylinder Head Bolt Tightening Sequence
G106521Courtesy of FORD MOTOR CO.
Fig 2: Timing Belt & Components
G106522Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals