Disc Brake Caliper & Pads - Rear (Probe): Installation

1. Install disc pads with anti-rattle clips, retaining clips and "V" springs in proper position, as marked at removal. Using piston remover, rotate piston clockwise until piston is fully seated in caliper. Align groves in piston with opening in caliper. See Fig 1 .
2. Lubricate guide pin bushings with high temperature grease. Install caliper on guide pin and pivot caliper onto anchor bracket. To complete installation, reverse removal procedure.

Fig 1: Positioning Piston in Rear Caliper (Probe)

Courtesy of FORD MOTOR CO.