Brake Pressure Control Valve - Sable & TAURUS Sedan: Installation
- Make sure the rear suspension is in full rebound. Ensure the red plastic gauge clip is in place on the valve and the operating rod lower adjustment screw is loose. Position valve assembly to underbody. Install 2 retaining bolts.
- To lower suspension arm, position valve lower mounting bracket and install one retaining screw. Ensure the valve adjuster is resting on the lower bracket. Tighten set-screw to specification.
- Connect 4 brake tubes in the same position as removed. Bleed the rear brakes. Lower vehicle after removing the red plastic gauge clip.