Rear Disc Brake Pads (Tracer Only): Removal
- Remove wheel and tire assembly. Using needle nose pliers, remove parking brake return springs at back of caliper. Loosen parking brake cable housing adjusting nut. Remove cable housing from bracket on rear lower control arm.
- Loosen attaching bolt connecting parking brake cable bracket to rear caliper. Remove parking brake cable from rear caliper. Loosen lower caliper bolt. Pivot caliper upward on upper caliper guide pins to service brake pads. Remove disc pad retaining spring.
- Remove disc pads and shims. Remove anchor plate clips from caliper anchor plate. Attach tape to anchor plate clips and label for installation.