LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1989 >> Bronco 5.0 N, Standard, M5OD-R2 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 5.0L V8 - VIN [N] & 5.8L V8 - VIN [H] >> Removal & Installation >> Rear Main Bearing Oil Seal

Rear Main Bearing Oil Seal

  1. Remove negative battery cable. Remove starter. Remove transmission. Remove flywheel/flexplate and engine rear cover plate.
  2. Using a sharp awl, punch a hole into the seal metal surface between the lip and the block. Using jet Plug Puller (T77L-9533), screw in threaded end of puller.
  3. Remove rear oil seal. Coat seal surfaces with light engine oil. Use a proper size seal installer and install seal until firmly seated. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals