LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1989 >> Bronco 5.0 N, Standard, M5OD-R2 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 5.0L V8 - VIN [N] & 5.8L V8 - VIN [H] >> Removal & Installation >> Engine Front Cover >> Installation

Engine Front Cover: Installation

  1. Clean all gasket surfaces. Align timing marks and install new front cover oil seal. Cut and fit new oil pan gasket. Apply sealer to oil pan gasket surface and install new gasket.
  2. Install oil pan front seal. Coat block and front cover with gasket sealer and position new gasket on block. Place front cover on cylinder block. Install Front Cover Aligner (T61P-6019-B). Coat front cover bolts with oil-resistant sealer, and install bolts.
  3. Tighten oil pan-to-front cover bolts while pushing in on front cover aligner. Tighten front cover bolts. Remove aligner. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals