LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1989 >> Bronco 5.0 N, Standard, M5OD-R2 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 5.0L V8 - VIN [N] & 5.8L V8 - VIN [H] >> Lubrication >> Oil Pump >> Installation

Oil Pump: Installation

  1. Prime oil pump by filling inlet opening with engine oil, then rotate pump shaft until engine oil emerges from outlet opening.
  2. Firmly seat intermediate shaft into distributor socket. Shaft stop should touch upper portion of crankcase. Position shaft stop as necessary.
  3. Remove shaft and insert into oil pump. Install and tighten shaft and pump as an assembly. Install oil pan.
CAUTION: If pump and shaft do not readily seat, do not force into position. Realign drive shaft hex with distributor shaft socket and reinstall.
scientia non olet · About LEMON Manuals