LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1989 >> Bronco 5.0 N, Standard, M5OD-R2 >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Rotor (Rear - "F" Series Super Duty) >> Installation

Rotor (Rear - "F" Series Super Duty): Installation

  1. Put electrical wiring over axle housing spindle to prevent damage. Apply sealant to hub-to-rotor screws. Place hub and rotor assembly onto axle housing spindle. Remove electrical tape. Install outer wheel bearing race and bearing. Install hub nut, ensuring hub nut tab is in hub tab slot before starting threads.
  2. Use Hub Wrench (T88T-4252-A) to tighten hub nut. Push inward on socket to prevent ratcheting action of hub nut. Rotate hub while tightening hub nut to 65-75 ft. lbs. (88-102 N.m). Back off hub nut 90 degrees, and retighten to 15-20 ft. lbs (20-27 N.m). End play of hub and rotor should be zero.
NOTE: Hub nuts are right-hand thread on both sides. Each hub is stamped RH to show thread direction. DO NOT use power impact tools to remove or install hub nuts. Hub nuts will ratchet unless Hub Wrench (T88T-4252-A) is used for removal and installation.
scientia non olet · About LEMON Manuals