LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1989 >> Bronco 5.0 N, Standard, M5OD-R2 >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Rotor (Front - 2WD) >> Installation

Rotor (Front - 2WD): Installation

  1. Pack needle and wheel bearings. Install inner wheel bearing and grease seal. Install hub and disc assembly on spindle. Install outer wheel bearing and adjustment nut.
  2. Spin rotor and tighten adjustment nut to 35 ft. lbs. (47 N.m). Back off nut 1/4 turn. Retighten adjustment nut to 16 in. lbs. (1.8 N.m). Carefully align closest hole in adjustment nut with center of spindle keyway. To complete installation, reverse removal procedure.
NOTE: Extreme care must be taken when aligning nut with center of spindle keyway to prevent damage to cam assembly locking key.
scientia non olet · About LEMON Manuals