LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1988 >> Tempo Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.3L HSC 4-CYL - VIN [X] & 2.3L OHC 4-CYL - VIN [S] >> Removal & Installation >> Intake & Exhaust Manifolds >> Removal

Intake & Exhaust Manifolds: Removal

  1. Disconnect negative battery cable. Drain cooling system. Remove air cleaner assembly. Remove heat stove tube at heat shield. Disconnect throttle cable. Mark and remove vacuum lines and electrical connectors.
  2. Remove 3 nuts attaching exhaust manifold-to-inlet pipe. Remove exhaust manifold heat shield assembly. Disconnect oxygen sensor. Disconnect throttle linkage. Remove thermactor check valve hose at tube. Remove EGR and bracket. Disconnect coolant inlet tube at intake manifold.
  3. On all models, mark and disconnect fuel lines to carburetor. Remove heater hose at fitting located under intake manifold. Remove intake manifold bolts and stud. Remove intake manifold. Remove exhaust manifold bolts. Remove exhaust manifold.
scientia non olet · About LEMON Manuals