LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1988 >> Tempo Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.3L HSC 4-CYL - VIN [X] & 2.3L OHC 4-CYL - VIN [S] >> Removal & Installation >> Cylinder Block >> Inspection

Cylinder Block: Inspection

  1. Using a feeler gauge and straightedge, check cylinder block head surface for flatness. Surface should be flate within .003" (.08 mm) over entire surface. Check cylinder bore for wear, taper, out-of-round and piston fit. See ENGINE SPECIFICATIONS tables at end of this article.
  2. Use only equal parts of kerosene and SAE 20 motor oil for honing cylinder bores. Install and tighten main bearing caps to specifications before cylinder refinishing. Use ONLY a spring-loaded type cylinder hone. After honing, allow cylinders to cool. Thoroughly clean bore with detergent and water solution.
  3. Rinse solution in bore thoroughly with clean water. Wipe bores clean with lint free cloth. Lubricate cylinder bores with engine oil. Tap cylinder head bolt threads in cylinder block.
scientia non olet · About LEMON Manuals