LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1988 >> Tempo Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.3L HSC 4-CYL - VIN [X] & 2.3L OHC 4-CYL - VIN [S] >> Overhaul >> Rear Crankshaft Oil Seal >> Removal

Rear Crankshaft Oil Seal: Removal

  1. Remove transaxle. On manual transaxle models, remove clutch disc, pressure plate and flywheel. See appropriate CLUTCHES article in this section. On automatic transaxle models, remove flexplate. See appropriate TRANSMISSION SERVICING article in this section.
  2. Use an awl and punch a hole into the metal surface of the seal. Use care not to damage sealing surfaces. Install Jet Plug Remover (T77L-9533-B) and remove oil seal.
scientia non olet · About LEMON Manuals