LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1986 >> Bronco II 4WD, Automatic >> Repair and Diagnosis >> Suspension >> Front Suspension >> Suspension - Front (4WD Coil) >> Removal & Installation >> Wheel Bearings >> Removal

Wheel Bearings: Removal

  1. Remove locking hubs. Remove wheel bearing lock nut, lock ring and adjusting nut. Remove hub/disc assembly. Outer bearing will slide out.
  2. Remove spindle nuts, then remove spindle from knuckle studs and axle shaft. Clean all parts, and remove spindle bore seal, "V" block seal and thrust washer from outer axle shaft. Replace any worn parts.
  3. Remove inner bearing cone and grease seal from hub with slide puller. Check bearing cups and drive out with punch if worn.
scientia non olet · About LEMON Manuals