LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1986 >> Bronco II 4WD, Automatic >> Repair and Diagnosis >> Suspension >> Front Suspension >> Suspension - Front (2WD Coil) >> Removal & Installation >> Ball Joints >> Removal (Stamped Front "I" Beam Axle)

Removal (Stamped Front "I" Beam Axle)

Remove spindle from vehicle as previously outlined. Remove snap ring from ball joints. Using "C" Frame (T74P-4635-C) and Receiver Cup (D81T-3010-A), press upper ball joint out of axle. Repeat procedure and press out lower ball joint.

CAUTION: Do not use heat on ball joint or axle during removal and installation procedures.
scientia non olet · About LEMON Manuals