Disc Rotor (4WD W/Manual Locking Hubs): Removal

Raise vehicle and support with safety stands. Remove wheel assembly and caliper. Remove retainer washers from lug nut studs. Remove locking hub assembly from spindle. See appropiate LOCKING HUBS under REMOVAL & INSTALLATION .
Remove snap ring from end of spindle shaft. Remove axle shaft spacer, needle bearing and bearing spacer. Remove wheel bearing outer lock nut using Front Wheel Bearing Spanner (T38T-1197-A).
Remove lock nut washer. Remove wheel bearing inner lock nut using spanner. Remove hub and disc assembly. Slide out outer wheel bearing hub is being removed.
Remove grease seal and inner wheel bearing. Inspect needle and wheel bearings for wear or damage. Inspect bearing cups for pits or cracks. Replace worn parts. If necessary, remove bearing cups with drift.