Disc Rotor (4WD W/Manual Locking Hubs): Installation

Pack needle and wheel bearings. Install inner wheel bearing and grease seal. Install hub and disc assembly on spindle. Install outer bearing and inner lock nut. Tighten lock nut to 35 ft. lbs. (47 N.m).
Spin rotor and back off inner lock nut 1/4 turn. Install lock washer. It may be necessary to turn inner lock nut slightly so that pin on lock nut aligns with closest hole on lock washer.
Install outer lock nut and tighten to 150 ft. lbs. (203 N.m). Install bearing spacer, needle bearing, and axle shaft spacer. Install snap ring. End play should be .001"-.003" (.025-.076 mm). Reverse removal procedure to complete installation.