Disc Rotor (4WD W/Automatic Locking Hubs): Removal
- Raise vehicle and support with safety stands. Remove wheel assembly and caliper. Remove retainer washers from lug nut studs. Remove locking hub assembly. See appropiate LOCKING HUBS under REMOVAL & INSTALLATION . Remove snap ring from end of spindle shaft.
- Remove axle shaft spacer, needle bearing, and bearing spacer. Being careful not to damage plastic moving cam, pull cam assembly off wheel bearing adjustment nut. Remove thrust washer and thrust (needle) bearing from adjustment nut.
- Look into spindle keyway, under adjustment nut hole. Remove locking key before removing adjustment nut. Remove adjustment nut using Socket (T7OT-4252-B). Remove hub and disc assembly. Outer wheel bearing will slide out as hub is being removed.
- Remove grease seal and inner wheel bearing. Inspect needle and wheel bearings for wear or damage. Inspect bearing cups for pits or cracks. Replace worn parts. If necessary, remove bearing cups with drift.