Brake Caliper: Reassembly
- Lubricate piston seal with clean brake fluid and install in cylinder bore groove. Lubricate cylinder with clean brake fluid. Coat piston and outside beads of dust boot with clean brake fluid.
- Push piston through boot until boot is around bottom (closed end) of piston. Position piston and boot directly over cylinder bore. Work bead of dust boot into groove near top of cylinder bore.
- With bead seated in groove, press straight down on piston until it bottoms in cylinder bore. Care must be taken not to cock or jam piston in cylinder. If necessary use a "C" clamp and a block of wood to bottom piston in cylinder.