Brake Booster: Removal
- Inside engine compartment, disconnect battery and remove tubes from primary and secondary outlet ports of master cylinder. Remove 2 nuts attaching master cylinder to brake booster assembly and remove master cylinder.
- Working inside vehicle below dash, remove stoplight switch wiring connector from switch. Remove push rod retainer and outer nylon washer from pedal pin. Slide stoplight switch along brake pedal pin just far enough for outer hole to clear pin. Remove switch by sliding it upward. Avoid damaging switch during removal.
- Remove booster-to-dash panel attaching nuts. Slide booster push rod and push rod bushing off brake pedal pin. Inside engine compartment, disconnect manifold vacuum hose from booster check valve. Move booster forward until booster studs clear dash panel and remove booster.