Intermediate Band

Intermediate Band Adjustment

1. Clean all the dirt from the band adjusting screw area. Remove and discard the locknut

2. Install a new locknut on the adjustment screw.

3. Tighten the adjusting screw using Band Adjusting Ratchet T71 P-77370-H and Socket T71 P-77370-D or equivalent. Tool T71 P-77370-H or equivalent, is a pre-set torque wrench which will click when the torque on the adjusting screw reaches 13.5 Nm (10 lb-ft).

4. Back off the adjusting screw exactly 4 1/4 turns.

5. Hold the adjusting screw from turning and tighten the locknut to 54 Nm (40 lb-ft).