Removal/Installation

E-100---350 & F-100---350 EXC. 4 WHEEL DRIVE MODELS
1. Raise and support front of vehicle.
2. On 1983---85 F-100---350 models, loosen flex coupling shield from steering gear input shaft shield and slide it up intermediate shaft.
3. On all models, disconnect flex coupling from steering shaft flange by removing 2 attaching nuts.
4. Disconnect drag link from pitman arm using tool No. 3290-C.
5. Remove Pitman to sector shaft attaching nut and washer, then remove pitman arm from gear sector shaft using tool No. T64P-3590-F.
6. While supporting steering gear, remove bolts and washer attaching gear assembly to frame side rail and lower gear assembly from vehicle.
7. Reverse procedure to install.