Ford Integral Carrier, 6.75" - Standard Differential

1. Mark differential case, cover and ring gear to facilitate assembly.
2. Using suitable puller, remove differential side bearings.
3. Remove and discard ring gear attaching bolts, then press ring gear from case.
4. Remove left side of differential case.
5. Using suitable drift, drive out differential pinion shaft lock pin.
6. Using brass drift, drive out pinion shaft. Clean and inspect all parts as outlined under ``Cleaning & Inspection,'' repairing or replacing parts as necessary.
7. Install differential side gears and thrust washers in their bores.
8. Install pinion shaft, aligning pinion gears and thrust washers.
9. Install left case on right and tap them together.
10. Install pinion shaft lock pin.
11. Using suitable press, install differential side bearings.