Instrument Cluster / Carrier: Service and Repair

Fig. 8 Instrument Cluster:

E-100---350
1. Disconnect battery ground cable.
2. Remove steering column shroud.
3. On models equipped with tilt steering column, loosen column-to-band C support to provide sufficient clearance for cluster removal.
4. On all models, remove 7 instrument cluster-to-instrument panel attaching screws.
5. Pull cluster back from panel and disconnect speedometer cable. It may be necessary to disconnect speedometer cable from transmission to provide access to the quick disconnect on the cluster.
6. Disconnect electrical connector from printed circuit board and remove cluster from vehicle, Fig. 9.
7. Reverse procedure to install.