LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1983 >> Ranger 2.0 C >> Repair and Diagnosis (Single Page) >> Suspension >> Front Suspension >> Suspension - Front (2WD) >> Removal & Installation >> Camber Adapter >> Removal

Camber Adapter: Removal

  1. Remove nut from upper ball joint stud. Strike inside of steering knuckle to pop upper ball joint taper loose from knuckle.
  2. If upper ball joint does not loosen, back lower ball joint nut 1/2 way down lower ball joint stud and strike side of lower steering knuckle. See Figure .
  3. Remove camber adjusting sleeve using camber adjuster remover (D81T-3010-B ).
scientia non olet · About LEMON Manuals