LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1983 >> Ranger 2.0 C >> Repair and Diagnosis (Single Page) >> Steering >> Manual Steering >> Steering Gear - Power >> Overhaul >> Worm & Valve Sleeve >> Disassembly & Reassembly

Disassembly & Reassembly

  1. Remove rings from sleeve with a small knife. Mount worm end of worm and valve sleeve assembly in a soft-jawed vise. Install a mandrell tool (T75L-3517-A1) over the sleeve. Install rings one at a time with the aid of a driver tool (T75L-3517-A2).
  2. Rapidly push down on pusher tool to force ring down ramp and into fourth groove of valve sleeve. Repeat three more times, each time adding spacers (Tool T75L-3517-A3) under mandrell tool to line up next groove.
  3. After all sleeve rings are installed, install sizing tool (T75L-3517-A4) carefully over valve sleeve rings. Be sure rings are not bent over as tube is slid over them. Remove sizing tool and check condition of rings. They must turn freely.
scientia non olet · About LEMON Manuals