LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1983 >> Ranger 2.0 C >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Overhaul - 4-CYL >> Seal Replacement >> Install Seal

Install Seal

  1. Install shaft protector over end of compressor shaft.

Tool Reference - No. 5 - Shaft Protector

  1. Coat shaft seal with clean refrigerant oil. Carefully engage tangs of shaft seal with slot in seal installer tool.

Tool Reference - No. 14 - Seal Remover/ Installer

Fig 1: Install Seal (1 of 2)
G17559
  1. Slide shaft seal and tool down compressor shaft, while turning tool. Apply light downward pressure until seal engages flats on shaft and is properly seated. Press down on tool and turn it to disengage tool from seal. Remove tool.
Fig 2: Install Seal (2 of 2)
G17560
scientia non olet · About LEMON Manuals