Rocker Arm Shaft Assembly: Removal
- Remove air cleaner assembly. Remove spark plug wires. Remove PCV valve and hose. Remove carburetor choke air deflector plate.
- Remove valve cover attaching bolts and washer. Make sure that washers are installed in their original positions.
- Disconnect transmission fluid dipstick tube from valve cover. Disconnect kickdown linkage from carburetor.
- Position thermactor air hose and wiring harness away from right valve cover. Remove engine oil fill cap.
- Disconnect vacuum line at canister purge solenoid. Disconnect hose from canister to purge solenoid. If equipped with power brakes, disconnect brake booster hose.
- Lightly tap valve cover with a plastic hammer to break seal. Remove valve covers. Loosen rocker arm shaft attaching bolts 2 turns at a time until all bolts are removed. Lift rocker arm shaft assembly from cylinder head.