LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1983 >> Ranger 2.0 C >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 2.8L V6 - VIN [S] >> Removal & Installation >> Camshaft Bearings >> Removal

Camshaft Bearings: Removal

  1. Remove engine from vehicle and place on engine stand. Remove flywheel. Remove camshaft. Remove rear bearing bore plug.
  2. Using camshaft bearing remover/installer (T71P-6250-A or equivalent), remove camshaft bearings from engine block. Use special adapter tube tool (T72C-6250 or equivalent), when removing front and rear bearings.
scientia non olet · About LEMON Manuals