LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1983 >> Ranger 2.0 C >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 2.8L V6 - VIN [S] >> Overhaul >> Rear Main Bearing Oil Seal >> Removal

Rear Main Bearing Oil Seal: Removal

  1. Remove transmission from vehicle. Remove pressure plate and clutch disc, if equipped. Remove flywheel, flywheel housing and rear plate.
  2. Punch 2 holes in rear main bearing oil seal. Punch holes directly opposite of each other. Install a sheet metal screw in each hole.
  3. Using 2 large screwdrivers, pry on both screws at the same time until seal is removed from engine block.
scientia non olet · About LEMON Manuals