LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1983 >> Ranger 2.0 C >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 2.8L V6 - VIN [S] >> Overhaul >> Rear Main Bearing Oil Seal >> Installation

Rear Main Bearing Oil Seal: Installation

  1. Coat outside diameter of oil seal with engine oil. Coat inside diameter of oil seal with Lubriplate.
  2. Using seal installer tool (T72C-6165 or equivalent), drive oil seal into engine block until seal is firmly seated. Reverse removal procedure to complete installation of remaining components.
scientia non olet · About LEMON Manuals