LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1983 >> Ranger 2.0 C >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Steering Column Switches >> Ignition Switch & Lock Cylinder >> Removal & Installation >> Lock Cylinder >> Removal (Bronco II & Ranger)

Removal (Bronco II & Ranger)

  1. Disconnect battery ground. Remove the trim shroud. Remove electrical connector from the key warning switch. Turn the lock cylinder to "RUN" position.
  2. Place a 1/8" diameter pin in the hole located in the outer edge of the lock cylinder housing. Depress the retaining pin, and pull out the lock cylinder.
scientia non olet · About LEMON Manuals